Neoline X-COP 9300s Schnellstartanleitung Seite 9

GPS time correction: auto time correction according to the time zone.
Date/time: setting date and time in case the GPS time correction is off.
Date and time OSD: (de)activating the video date and time OSD.
Speed OSD: (de)activating the car speed OSD.
<100 km/h speed OSD: (de)activating the car speed OSD ONLY shown when the speed is less than
100 km/h.
Night mode: setting the time the night mode video recording activates.
In the night mode, the video is noisier; yet, more details in dark areas of the road OR roadsides are
visible.
Car registration number OSD (enter the number): (de)activating the car registration number OSD.
Low voltage turnoff: setting the lowest voltage the device is on at, any lower voltage turning it off.
Language: selecting the interface language.
Default settings: setting the default settings.
Distribute memory card capacity: auto distributing the memory card capacity between the Driving,
Event and Parking folders.
Format memory card: deleting all the memory card data.
Software version: showing the SW current version
Radar detector settings
Auto mute: decreasing the volume by 30% within 6 seconds after the detected signal announcement
starts. The volume will be restored 10 seconds after the announcement ends.
GPS mute unless: while the car speed is less than the set value, no GPS sound announcement is
made.
NOTE: This feature is unavailable when the X-COP mode is on.
RD mute unless: while the car speed is less than the set value, no radar detection sound
announcement is made.
Voice: enabling/disabling police radar voice notification.
Sound: enabling/disabling all sound notifications.
GPS announcement: enabling/disabling announcements of police radars and cameras registered in
the current GPS database.
RD announcement: enabling/disabling the RD police radar announcements.
GPS priority: prioritizing the GPS announcements. (When on, the GPS announcements are both visual
and audial, while those of the RD are only visual).
RD priority: prioritizing the RD announcements. (When on, the RD announcements are both visual
and audial, while those of the GPS are only visual).
Auto Turbo: auto switching to the Turbo mode once the set speed is reached.
Silent Zone Radius: setting incoming broadband signal announcements off within the specified
radius.
Red Zone Radius: setting the radius of the Red Zone (a zone where your special attention is required,
e.g. a section of speed bumps, a school, a busy intersection, a quick hide, etc.)
Overspeed tolerance: the set value is added to the allowed speed value for each camera set in the
GPS database.
Maximum speed: if the car speed is higher than the set value, a sound announcement is generated.
GPS announcement distance: it is the distance to the ahead GPS database point where the GPS
announcement starts; the distance may be defined:
• By the database: each camera in the database has its own announcement distance (m).
• By settings: 300 m / 400 m / 500 m / 600 m/ 700 m / 800 m / 900 m
• Based on the current vehicle speed:
0 km/h to
Speed
60 km/h
Announcement
600m
distance
61 km/h to 71 km/h to
70 km/h 80 km/h
650m 700m
8
81 km/h to 91 km/h to
90 km/h 100 km/h
750m 800m
101 km/h to
110 km/h
110 km/h
850m 900m