Operation Conditions - Neoline X-COP 9300s Schnellstartanleitung

Operation Conditions

1. Install the hybrid in accordance with the manual.
2. Only use the supplied power cord. Using a third-party charger may compromise the device
performance.
3. Observe the storage and operation temperature conditions. Avoid extra sunlight exposure.
4. When leaving the car, make sure the device is turned off; avoid leaving a powered device
unattended for too long, as this can cause excessive car battery consumption and reduce the device
life.
5. Avoid dropping/jamming the device.
6. To avoid accidents, never do anything to the device while driving.
7. Before cleaning the car interior, remove the hybrid to avoid cleaning agent spilt on it, as this can
compromise the appearance and/or performance of the device.
8. Do not install the device where the airbag appears.
9. Use the voltage of 12-24 V.
10. Avoid any covers on the device when operating.
11. The hybrid readings may be inaccurate due to possible third-party emissions. Powerful
transmitters may affect proper operation of the device. Such transmitters may include, without
limitation: car dead zone sensors, sliding door motion sensors, cellular network base stations,
non-standard electronic devices in the car (mobile phones, other GPS/radar detector devices, etc.)
Detection of secondary transmitters is not a device malfunction.
12. The hybrid is only intended for detecting sources of radio emissions. The manufacturer cannot
guarantee detection of all the sources nearby since the instruments are developing constantly.
13. The hybrid may operate incorrectly where there are athermal or heated windshields. The coating
may compromise detection of broadband signals and correct operation of the GPS module.
14. Mounting the device with 3M adhesive type is only possible once. Therefore, choose the location
wisely.
15. Never remove the memory card during operation, for it may corrupt the data or affect the unit.
16. To record high-quality video, make sure the camera view is unobstructed and the camera lens is
clean.
17. When driving, the unit is affected by vibrations that may corrupt the camera focus Check the
camera focus carefully before use.
18. The manufacturer recommends using only memory cards of Class 10 or higher. The following
Class 10 memory cards have been tested to work correctly with the hybrid: Samsung EVO Plus,
Toshiba Exceria, Sony micro SDHC, Kingston micro SDXC, Transcend Premium 400x, Qumo micro
SDXC. Beware of counterfeits!
19. Format the micro SD card every two months to avoid damages to the file system.
20. The built-in supercapacitor helps you finish your recording correctly. Normal operation of the
10