Repeater Mode - Hama N300 Bedienungsanleitung

B) Access point mode:
The repeater is connected to your existing network
through a wired connection and, after
configuration, sets up an independent wireless
network.
Note
The setup of this mode is described in the
product's operating instructions, which you
can access at www.hama.com by entering the
item number.

6.2. Repeater mode

Note
Please observe the detailed operating
instructions available at www.hama.com. They
offer detailed, useful information on additional
options for starting up and configuring your
product.
6.2.1 Start-Up using WPS (WiFi protected
setup)
Requirements:
In order for you to use WPS, your existing WLAN
router must support configuration using WPS.
In addition, your WLAN router must be currently
using the WPA or WPA2 WLAN encryption
standard, and the SSID (WLAN network name) of
the WLAN router must be set to visible.
Note
Note that some manufacturers use designations
other than WPS. Please read the instructions for
your WLAN router to determine whether and
how you can activate linking via a hardware
button (WPS) on your WLAN router.
To set up the Hama repeater using WPS, proceed
as follows:
• Plug in the Hama repeater in the immediate
vicinity of your WLAN router (we recommend
starting up the device in the same room in
which your WLAN router is located) and wait
until its status LED (4) lights up.
• Press and hold the WPS button (3) for
approximately 2 seconds. The status LED (4)
begins to flash quickly.
• Press the WPS or QSS button on your WLAN
router within the next 2 minutes and according
to the instructions in your WLAN router manual.
(Consult the instructions for your WLAN router
to determine how long to hold the button.)
• Wait for approx. 3 minutes until the connection
between the WLAN router and the repeater
is established.
5