Led Indicator; Standard Parameters; Operating Modes - Hama N300 Bedienungsanleitung

5.2. Network port
You can connect your PC or console to this
network port in order to provide these devices
access to your WLAN network device.
5.3. WPS button (6)
This button can be used to connect/link the
repeater to your WLAN router using WPS; it can
also be used to reset the repeater to the factory
settings in case of a malfunction. To make a
connection/link using WPS, please read the section
Start-Up Using WPS.
Restoring the factory settings:
If a connection to the configuration program
cannot be established, reset the device to the
factory settings by pressing the WPS button for
approx. 6 seconds.

5.4. LED indicator

Status LED
Constant light
Off
Flashes slowly
Flashes quickly
4
Repeater is switched on
Repeater is switched off
Repeater is not
connected to a network
Repeater is connecting
to a network

5.5. Standard parameters

URL
IP address
Password
SSID
WiFi key
6. Getting started

6.1. Operating modes

The repeater basically supports two different
operating modes:
A) Repeater mode:
The repeater strengthens your wireless network; it
is connected to the existing router/access point via
WLAN. Here, the SSID and password of your
existing network are copied.
Note
The setup described in this quick guide relates
solely to the repeater mode!
http://ap.setup
192.168.10.1
admin
Wireless-N
None / No key is
necessary for connection