Cleaning The Water Tank; Cleaning The Evaporator - smartmi 2 Bedienungsanleitung

Maintenance and installation
Turn the humidifier off and disconnect it from the power supply before performing the following operations.

Cleaning the water tank

To prevent the water tank from becoming contaminated and
producing odors, rinse the water tank with clean water or
wipe it with a soft cloth to keep it clean.
There are drainage holes at the bottom of the water tank. Do
not use the water tank straight away after it has been fully
rinsed or after adding too much water by accident. Instead,
place the water tank on the ground with the drainage holes
facing down to drain the water from inside the tank.
It is recommended to clean the
water tank once a week or as
required by the frequency of use.
Air-drying mode
Enabling air-drying mode
When the water tank is less than 10% full, the humidifier will
continue to run for about 8 hours to air dry the water in the
water tank and prevent contamination and odors.
Disabling air-drying mode
When the water tank is less than 10% full, the humidifier
automatically stops running.
Tip: You can enable or disable air-drying mode using the "Mi Home /
Xiaomi Home" app.
Drainage
holes
8

Cleaning the evaporator

The evaporator can be removed and wiped with a
soft cloth or rinsed with clean water. You can also
turn the knob to remove each disc of the evaporator
for servicing and cleaning.
As shown in the figure, the
evaporator discs can be removed
by turning the knob clockwise.
Note: Clean the water tank using clean water at room
temperature only. Do not add fragrances such as essential oils
to the water. After use, immediately drain the water in the water
tank and any water remaining in the unit to prevent the unit from
becoming contaminated by bacteria and other microorganisms.