Bontrager TLR Montageanleitung Seite 7

9. Check for correct tire bead engagement in the rim (Figures 8 and 9).
Most tires have a mold line near the bead of the tire where it engages
the rim. All the way around the rim, the distance between the mold line
and the top edge of the rim must be even and equal. If the distance is
not equal, deflate the tire and repeat steps 7 and 8.
x
x
Figure 8. Correct. Make sure the
mold line of the tire is
equal (X distance) with
the rim all the way around.
10. Bounce the wheel on the ground while spinning it. This spreads
the sealant over the entire inner surface of tire.
11. Re-check the tire inflation and if need, correct it.
12. Re-check for correct tire bead engagement (Figure 8 and 9).
Check the tire sealant every 3 to 4 months. Add more as needed.
x x
Figure 9. Incorrect. The mold line of
x
the tire is not equal all the
way around.
EN
x
6