Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Be sure the rim strip snaps into place under both beads.
5. Align the flat sides of the valve base with the walls of the rim (Figure 3
& 4).
6. Tighten the valve nut over the threads of the valve until finger tight. Do
not tighten with a tool.
7. Work the rim strip into the rim, moving away from the valve stem in both
directions using only your thumbs. Do not use tools because they can
damage the rim strip.
Figure 3. Correct alignment. Flat
sides of valve are aligned
with rim wall.
Figure 4. Incorrect alignment. Flat
sides of valve not aligned
with rim.
EN
2
Werbung
