Operation - Waeco AirCon Service TPOPUVP Bedienungsanleitung

Operation

Before first use
➤Fully charge the battery before first use (see
chapter "Charging the battery" on page 6).
Adjusting the LED violet light lamp
I
NOTE
• Use a wide beam profile to scan a
large area for leaks.
• Use a narrow beam profile to iden-
tify small leaks.
• Low light intensity helps to reduce
glare.
• The strobe light feature helps to
contrast and identify leak areas.
Adjusting the beam profile
➤Turn the lamp head counterclockwise to
widen the beam profile.
➤Turn the lamp head clockwise to narrow the
beam profile.
Adjusting the light intensity
1. Press the ON button (fig. 1 1, page 3) to
activate high light intensity.
2. Press the ON button (fig. 1 1, page 3)
again to activate low light intensity.
3. Press the ON button (fig. 1 1, page 3) a
third time to activate the strobe light fea-
ture.
Detecting leaks
1. Turn off the engine.
I
NOTE
Observe the local regulations for han-
dling chemicals.
2. Add the appropriate fluorescent dye to the
fluid system.
3. Start the engine and run the system for
5 to 10 minutes to circulate the dye.
4. Turn off the engine.
I
NOTE
Use in low-light conditions to achieve
the best inspection results.
6
5. Put on the supplied fluorescence enhanc-
ing goggles.
6. Adjust the LED violet light lamp (see
chapter "Adjusting the LED violet light
lamp" on page 6).
7. Scan the system with the LED violet light
lamp.
✔ Leaks will show a bright fluorescent glow.
8. Repair any leaks.
9. Clean the remaining dye from the leak
sites with a suitable dye cleaner.
10. Reinspect with the LED violet light lamp to
ensure all dye residue has been removed.
I
NOTE
Residual dye could give a false leak
indication.
11. Run the engine for 5 to 10 minutes.
12. Reinspect with the LED violet light lamp.
✔ No glow means that all leaks have been
repaired.
Charging the battery
I
NOTE
• A full charge will take approxi-
mately 5 hours to complete.
• The product can be used while
plugged into the battery charger.
1. Plug the battery charger into a power out-
let.
2. Firmly plug the power connector into the
socket located on the side of the lamp.
✔ The voltage indicator light on the lamp
(fig. 1 6, page 3) and on the battery char-
ger (fig. 1 5, page 3) both light up green as
soon as the lamp is fully charged.
4445103798
EN