EcoFlow Smart Generator Dual Fuel Benutzerhandbuch Seite 12

1. Place the generator on a level plane.
2. Turn the maintain cover knob to
3. Unscrew the lid and oil dipstick.
4. Inject the specified amount of recommended engine oil, and screw
the lid and oil dipstick closed tightly. Reinstall the maintenance cover
and turn the knob to Closed.
Recommended engine oil: SAE SJ 10W-40
Grade of recommended engine oil: API Grade SJ or higher
Oil capacity: 0.1 gal. / 0.38 L
Rechargeable Battery Connection
The generator cannot be started by the Electric Start switch unless
connected to the internal battery.
Turn the maintain cover knob to
and connect the positive and the negative wires of the battery
respectively.
Checking Before Use
Warning Please check the following components carefully each time before using the generator.
a) Check the fuel level(when using gasoline)
Take off the fuel cap and check the fuel level. Inject more fuel into the tank if the fuel level is too low.
(when using LPG)
b) Check the LPG
Open the LPG cylinder valve, and use soapy water to soak all the connections on the LPG hose to check
for leaks. If bubbles appear or bubbles grow, then this indicates a leak in the LPG hose. If the leak is at a
fitting, then turn off the valve on the cylinder and tighten the fitting. Open the valve again and use
soapy water to recheck the fitting, then turn off the valve on the cylinder and tighten the fitting. If the
leak continues, or if the leak is not at the fitting, then stop using the generator and contact customer
support.
8
and take off the maintenance cover.
, take off the maintenance cover
Refilling the engine oil
Connecting the positive
and negative wires