Intended Use; Unpacking; Connecting And Printing - OHAUS SF-110B Bedienungsanleitung

EN-2
1.2

Intended Use

This instrument is intended for use in businesses and light industry. It shall only be used
for measuring the parameters described in these operating instructions. Any other type
of use and operation beyond the limits of technical specifications, without written
consent from OHAUS, is considered as not intended. This instrument complies with
current industry standards and the recognized safety regulations; however, it can
constitute a hazard in use.
If the instrument is not used according to these operating instructions, the intended
protection provided by the instrument may be impaired.
2 INSTALLATION
2.1

Unpacking

Carefully remove your SF-110B printer and each of its components from the package.
Save the packaging to ensure safe storage and transport.
Please read the manual completely before installing and using the printer to avoid
incorrect operation. Components included:
Printer
•
Power Adapter with plugs*
•
RS232 Cable
•
Ink Ribbon
•
Note: * The included plugs vary depending on the region.
2.2

Connecting and Printing

Before connecting, make sure the instrument and printer have the same RS232
parameter setting. For instrument Baud rate settings, please see the related manual.
Choose and install the proper power adapter converter according to the
•
located country/region.
Disconnect the power supply.
•
Connect the printer to the instrument with the RS232 cable.
•
Connect the printer to the mains power and use the main switch <I/O> to
•
power on the printer.
Press PRINT key on the printer or on the instrument.
•
Note: Depending on the output setting of the weighing instrument, it may be necessary
to wait for the data to stabilize after pressing the print key, but not immediately.
User Guide
•
Paper Roll
•
Paper Rotary Axis
•
SF-110B