OHAUS SF-110B Bedienungsanleitung Seite 3

SF-110B
1 INTRODUCTION
Thank you for purchasing this product.
This User Guide contains installation, operation, and maintenance instructions for
SF110B printer. Please read it completely before installation and operation. For further
detail information, consult the Instruction Manual on www.ohaus.com.
1.1 Safety Precautions
Signal Words
For a hazardous situation with medium risk, possibly resulting in
WARNING
severe injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the
CAUTION
device or the property or in loss of data, or minor or medium injuries
For important information about the product. May lead to equipment
ATTENTION
damage if not avoided.
NOTE For useful information about the product.
Warning Symbols
General hazard
Safety Precautions
CAUTION: Read all safety warnings before installing, making connections,
or servicing this equipment. Failure to comply with these warnings could
result in personal injury and/or property damage. Retain all instructions for
future reference.
Before connecting power, verify that the AC adapter's input voltage range and
•
plug type are compatible with the local AC mains power supply.
Do not position the equipment such that it is difficult to reach the power
•
connection.
Make sure that the power cord does not pose a potential obstacle or tripping
•
hazard.
Operate the equipment only under ambient conditions specified in these
•
instructions.
This equipment is for indoor use only.
•
Do not operate the equipment in wet, hazardous, or unstable environments.
•
• Do not allow liquids to enter the equipment.
Do not place the equipment upside down on the platform.
•
Use only approved accessories and peripherals.
•
Disconnect the equipment from the power supply when cleaning.
•
Service should only be performed by authorized personnel.
•
WARNING: Never work in an environment subject to explosion hazards!
The housing of the instrument is not gas tight. (Explosion hazard due to
spark formation, corrosion caused by the ingress of gases)
Explosion hazard
EN-1