Installation - DeLonghi DD95 Gebrauchsanweisung

Installation

Place the appliance in the room that you wish to dehumidify.
It is essential to leave a space of at least 50 cm. around the appliance in order to ensure adequate ventilation.
The condensation can be discharged in one of two ways:
A) Discharge into the canister
The condensation generated by the dehumidifier can be discharged directly into the canister.
The canister is easy to extract when it needs to be emptied. It has an ergonomic form and is equipped with
2 handles which makes it easy to carry and to empty.
B) Continuous External Discharge
If you need to have the appliance working for a long period of time but are unable to empty the canister
repeatedly, it is possible to use the continuous discharge.
It is extremely easy to set the tank up for continuous discharge.
1) On the tank there is a thin part easy to cut to allow the hose to pass through (fig. 1).
2) Remove the rubber cap from the spout.
3) Make a hole on the inside of the tank spout using a drill with a fine bit.
4) Insert a 10 mm diam. hose into the spout (Fig.2)
5) Replace the canister into the appliance (Fig.3).
N.B. Keep hold of the rubber cap: it can be used both for blocking the hose and for plugging the spout
if the canister is used for discharging in the future (see point A).
Fig. 1
Canister Control System
This dehumidifier is equipped with a special intelligent device which checks that it is working properly.
A warning lamp placed on the control panel comes on to warn the user when:
1. the canister is full
2. the canister is missing
3. the canister is badly positioned
4. you are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill"
remove the blockage.
Once the cause has been removed, the warning lamp goes off and the appliance starts working again.
12
spout with
rubber cap
part to be cut
empty the canister
put the canister back into position
position it correctly
Fig. 2 Fig. 3