Hama 00176614 Bedienungsanleitung Seite 5

• Do not continue to operate the device if it is
visibly damaged
• No bare spots must be visible after connection
• This product is intended for private, non-
commercial use only.
• Do not use the product in areas in which
electronic products are not permitted.
• Keep the packaging material out of the reach of
children due to the risk of suffocation.
• Do not mount the product above locations where
persons might sit or stand.
• Pay attention to the applicable data protection
regulations before installing and using the
product.
• Respect the personal and property rights of
others. Do not make recordings of other people
with the camera.
• Observe the right to one's own image and spoken
word when recording.
4. Technical data
Power supply
Frequency band
Maximum radio-
frequency power
transmitted
5. Start-up and operation
Warning
• Please note that lights (even LEDs) can
generate heat and may become hot. Always let
the light cool down for a few minutes before
touching it.
• The device may only be operated on a 230
V 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certi ed in your country. The
applicable accident prevention regulations must
be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch off
the automatic circuit breaker). Failure to comply
with the installation instructions can cause res
or other hazards.
230 V
2.4 GHz
< 100 mW
Risk of electric shock
Do not open the product and do not operate it if
it is damaged, if smoke, a strange smell or loud
noises are coming from it. Immediately contact
your dealer or our service department (see item
"Service and Support").
Note
Replaceable light source by
a professional (LED only).
Warning
Never look straight into the light source and do
not aim its beam of light straight into the eyes of
other people or animals. This could
damage your/their eyes.
Note
This light contains a light source of energy
e ciency class "F".
6. Installation
• Switch off the relevant fuse (fuse box) for the
room in which you wish to install the light.
• Check that the wires are de-energised using a
suitable measuring device (e.g. multimeter).
1. Please break through the pre-perforated opening
on the rubber grommet in the plate in order to
thread the cables through as shown in Fig. 2.
2. Attach the plate using the supplied screws and
plugs to the position you have determined on the
wall. (Figure 2)
3. Attach the cables on the product's terminal block.
See Figure 3.
4. Fit the camera to the pre-mounted plate on the
wall. To do this, use the 2 short screws and the
close the holes with the rubber plugs supplied.
5. Switch your fuse back on.
7