Electrical Connection - Küppersbusch KI6130.0SE Bedienungsanweisung Mit Montageanweisungen

EN
Installation
Installation with cutlery drawer
If you wish to install furniture or a
cutlery drawer under the hob, a sepa-
ration board must be fitted between
the two. Accidental contact with the
hot surface of the device's housing is
thus prevented.
The board must be fitted 20 mm bene-
ath the under part of the stovetop.

Electrical connection

Before you connect the stovetop to
the mains, check that the voltage
and frequency match those specified
on the stovetop nameplate, which is
underneath it, and on the Guarantee
Sheet, or if applicable on the technical
data sheet, which you must keep
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
top housing or the oven housing, if it
is installed in the same unit.
Warning:
The electrical connection must
be properly grounded, following
current legislation, otherwise the
induction hob may malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
Only the Küppersbusch
o f f i c i a l t e c h n i -
cal service can handle or repair the
appliance, including replacement
of the power cable.
Before disconnecting the hob
form the mains, we recommend
switching off the cutoff switch and
waiting for approximately 25
seconds before disconnecting from
14
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
About induction
Advantages
With an induction hob, the heat is
transmitted directly to the pan.
This has a number of advantages:
-Saves time.
-Saves energy.
-Easy to clean as if the food comes
into contact with the glass plate, it does
not burn easily.
-Improved energy control. The energy
is transferred to the pan as soon
as the power controls are pressed.
In addition, as soon as the pan is
removed from the cooking zone, the
power supply stops. It is not necessary
to switch the power off first.
Pans
Only ferromagnetic pans are suitable
for use with an induction hob.
There are several types:
-cast iron, enameled steel, and
stainless steel pans specifically for
use with induction hobs.
We do not recommend the use of
diffuser plates or materials such as fine
steel, aluminum, glass, copper, or clay.
Each cooking zone has a minimum
pan detection time. This depends on
the material and the ferromagnetic
diameter of the base of the pan.
Therefore it is essential to use the
cooking zone that best matches the
diameter of the base of the pan to
be used.
If the pan is not detected on the
selected cooking zone, try using the
next smallest zone.
When the Flex Zone is used as a
single cooking zone, larger pans
suitable for this type of zone can be
used (see fig. 2).
Fig. 2