Bios Setup; Menu Descriptions - Werock Rocktab S500 Betriebsanleitung

Power Management Problems
The computer does not automatically enter sleep or hibernation mode.
If you have a connection to another computer, the computer does not enter Hibernate or Sleep mode when
the connection is active.

Make sure that the sleep or hibernation timeout is enabled. The computer does not enter Sleep or
Hibernate mode immediately.

When the computer performs an operation, it usually waits until the operation is complete.
The computer does not return from Hibernation or Sleep mode.

The computer automatically enters Hibernate or Sleep mode when the battery is depleted. Perform
one of the following steps:
o Connect the AC adapter to the computer.
o Replace the dead battery with a fully charged battery.
An application program is not working properly.

Make sure the software is installed correctly.

If an error message appears on the screen, refer to the software program documentation for more
information.

If you are sure the operation has stopped, reset the computer.

BIOS Setup

BIOS Setup Utility is a program for configuring the computer's BIOS (Basic Input/Output System) settings.
BIOS is a software layer, also called firmware, that translates instructions from other software layers into
instructions that the computer hardware can understand. BIOS settings are required by your computer to
identify the types of devices installed and to set up special functions. This chapter tells you how to use the
BIOS Setup utility.
When and how to use it
You need to run the BIOS Setup utility when:

You see an error message on the screen prompting you to run the BIOS Setup Utility.

you want to restore the factory default BIOS settings.

You want to change some specific settings according to the hardware.

You want to change some specific settings to optimize the system performance.
To run the BIOS setup utility:
1.
Click → "Settings" → "Update & Security" → "Restore". Under Advanced Startup, click "Restart
now". In the Startup Options menu, click Troubleshooting → Advanced Options → UEFI Firmware
Settings. Click Restart.
2.
Generally, you can use the arrow keys to move around and the + / - keys to change the setting
values. Keyboard information can be found at the bottom of the screen.
NOTE:

The actual setting items of your model may differ from those described in this chapter.

The availability of some setting items depends on the version of Windows running on your computer.

Menu Descriptions

Rocktab S500 User Manual
102 / 110