Werock Rocktab S500 Betriebsanleitung Seite 101

The screen suddenly goes black and the power indicator goes out
 Make sure that the power adapter is properly connected.
If the device is running on battery power, the battery may be dead. Charge the battery.

The quality of the wireless LAN signal is poor
The notebook may be out of range. Move the notebook closer to the access point or another

wireless LAN device that is connected to it.
 Check if there is any interference in your environment, such as microwave ovens, cordless phones.
Move the tablet away from objects that cause interference.
I cannot connect to another wireless LAN device.
Make sure the wireless LAN function is turned on.

 Make sure the SSID setting is the same for each wireless LAN device on the network.
Reboot the notebook.

 Make sure the IP address or subnet mask setting is correct.
I can't connect to another device with Bluetooth
 Make sure that Bluetooth is turned on for both devices.
Make sure the distance between the two devices is 10 meters max and there are no walls or major

obstacles between the devices.
 Make sure both devices are turned on and configured to be detected.
Make sure that both devices are compatible.

The GPS application cannot find my location
Make sure that the GPS is turned on.

 Make sure the GPS receiver and location sensor are enabled in the control panel.
The notebook may be out of range of reception.

 Move the notebook outside or closer to a window.
 Check for interference in your environment, such as microwave ovens, cordless phones. Move the
notebook away from objects that cause interference.
No sound is output
Adjust the volume of the notebook by pressing the volume controls.

 If you are using an external audio device, make sure the cable is connected properly.
The computer does not recognize a newly installed device.
heck if a device driver needs to be installed. (Refer to the documentation supplied with the device).

The device may not be configured correctly in the BIOS setup program. Run the BIOS setup
program to identify the new type.

Check the cables or power cords for proper connections.

For an external device that has its own power switch, make sure the device is turned on.
I cannot access the LAN network.

Make sure the LAN cable is properly connected to the RJ-45 port and the network hub.

Make sure the network configuration is correct.

Make sure the user name or password is correct.
Rocktab S500 User Manual
101 / 110