Hama Nano Bedienungsanleitung Seite 6

Warning - Batteries
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Only use batteries (or rechargeable batteries) that match
the speci ed type.
• Before you insert the batteries, clean the battery
contacts and the polarity contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries, or batteries of
different types or from different manufacturers.
• Remove the batteries from products that are not being
used for an extended period (unless these are being
kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of
them without delay.
• Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
4. First steps - Inserting the batteries
Note
• Alkaline batteries are recommended. Use two batteries
of the type "AAA" (LR 03/Micro).
• Remove the battery cover on the back of the universal
remote control (A).
• Insert the batteries, observing the "+/-" marks for
polarity (B).
• Close the battery compartment (C).
Note: Code memory
• Each programmed code or taught-in button is retained
even during battery replacement.
Note: Energy saving function
• The remote control switches itself off automatically if
a button is pressed for longer than 15 seconds. This
prolongs the life of the batteries if the remote control
is stuck in a place where the buttons are pressed
permanently, e.g. between sofa cushions.
Note: Low battery display
• This remote control indicates when the batteries are
getting low.
• If the status LED ashes 2 times after a button is
pressed, the batteries are weak and should be replaced
promptly.
5. Setup
Note
• For proper infra-red transmission, always hold the
remote control in the approximate direction of the
device to be operated.
• You cannot operate a device with the universal remote
control while it is in Setup mode. Exit Setup mode
and select the device to be operated using the device
selection buttons.
• Please note that the remote control emits infra-red
signals. These are not visible to the human eye.
3