Taking Measurement - Eks 0315 Bedienungsanleitung

APPLYING THE ARM CUFF
1. Place your elbow on a table with the palm of your hand
facing upward and wrap the arm cuff around your upper
arm.
2. Pull on the end of the cuff until it wraps securely around
your upper arm. Do not over tighten the cuff. Allow 1-2
cm or ½ inch between the bottom of the cuff and your
elbow joint.
3. Make sure the monitor is at the same level as your heart.
User setting
This unit allows the measurement records of a maximum of 2 users to be stored in different
user pages. Press "paget" button to switch between user page 1 and 2.

TAKING MEASUREMENT

Note:
• Avoid smoking, eating or exercising for 30 minutes before making a measurement.
• Do not move or talk during measurement.
• Measurements can be made with either arm.
Sitting correctly
1. Relax
2. Sit upright in a chair with both your feet on the floor.
3. Remove tight fitting or thick clothing from you upper arm. Do
not roll up your sleeve if it is too tight.
4. Place your arm on a table so that the monitor is at the same level
as your heart.
Making a measurement
1. Press the "POWER" button. The cuff will automatically inflate and the measurement will
start.
2. Press the "START" button. When the measurement is complete, the cuff will
automatically deflate and your systolic and diastolic pressure values and pulse rate will
be displayed.
3. Remove the arm cuff and take note of your measurement results.
Note:
You can press the "POWER" button to stop measurement at any time
HEARTBEAT READINGS
Besides Systolic and Diastolic values, your
pulse rate will also be displayed
after a measurement.
Pulse

Left arm