Sharp androidtv 65FN2EA Schnellstartanleitung Seite 5

EN
What is included in the box
Supply of this TV includes following parts:
• 1x TV
• 1x Remote control
• 2x AAA batteries
Attaching the Stand
Please follow the instructions in Technical leafl et, located in the
accessories bag.
Wall mounting the TV
1. Remove the four screws that are supplied in the wall mounting holes.
2.
The wall mount can now be easily attached to the mounting holes on
the rear of the TV.
3.
Install the wall mounting bracket to the television as advised by the
bracket manufacturer.
Some TVs come with spacers and longer screws for wall mounting. When
fi xing the wall mount brackets on model that has spacers supplied, instead
of screws provided in TV wall mounting holes, we recommend the use of
longer screws and spacers included in the accessory pack. Please put spac-
ers into TV wall mounting holes, located on the back of the TV, then put
wall brackets onto them. Attach the brackets and spacers to the TV using
longer screws as shown below:
2
1
3
1. TV
2. SPACER
3. SCREW
NOTE: TV and the wall bracket type shown in the
diagram is for illustration purposes only.
Connections
Connecting external devices see last page in this IM.
Getting started - initial set up
1.
If rubber parts, foam parts or tape are attached to the TV frame, please
remove them gently.
2.
Using the antenna cable (not supplied), connect the TV to the antenna
wall socket.
• 1x TV stand installation packet
• 1x Quick Start Guide
3. For connecting to the Internet with a wired connection connect a
Cat 5/Ethernet cable (not included) from the TV to your broadband
modem/router.
4. Insert the batteries supplied into the Remote control.
5. Connect the power cable to the Electrical outlet.
6.
Then press Standby button to power on TV.
7. After turning the TV on, you will be welcomed by the First Time
Installation menu.
8. Please select language for TV menu.
9. Please set desired settings in remaining screens of First installation
menu.
TV buttons*
Vol+ Volume up and menu right
Vol- Volume down and menu left
CH+ Programme/Channel up and menu up
CH- Programme/Channel down and menu down
MENU Displays Menu/OSD
SOURCE Displays the input source menu
STANDBY Standby Power On/Off
* - for TV with buttons
TV Control Stick*
TV control stick is located on the lower left corner of back side of the TV.
You can use it instead of remote control to control most of the functions
of your TV.
While TV is in standby mode:
• short press of control stick - Power On
While watching TV:
• RIGHT/LEFT – volume up/volume down
• UP/DOWN – changes channel up/down
• short press – Displays Menu
• long press – Standby Power Off
While in menu:
• RIGHT/LEFT/UP/DOWN – navigation of cursor in on-screen menus
• short press – OK/Confi rm selected item
* - for TV with control stick
Choosing Mode Input/Source
To switch between the diff erent input/connections.
a) Using the buttons on the remote control:
1. Press [SOURCE/ ] - The source menu will appear.
2. Press [▲] or [▼] to select the input you require.
3. Press [OK].
b1) Using the buttons* on the Television:
1. Press [SOURCE].
2. Scroll up/down using CH+ / CH- buttons to the input/source you
require.
3. Press [VOL+] to change input/source to the one selected.
b2) Using the TV control stick*:
1. Shortly press control stick to enter menu.
2. Press control stick down and navigate cursor to SOURCES menu.
3. Shortly press control stick to enter SOURCES menu.
4. With control stick choose the input/source you require.
5. By short press of control stick, you will change input/source to the
one selected.
* - optional
3