Cleaning And Maintenance - WMF Bueno Gebrauchsanweisung

Use
This toaster is suitable for standard slices of bread, slices of bread (up to 9x9 cm in size), plaited yeast
buns and similar bakery products with a maximum thickness of 2,6 cm.
Only use bakery products without fillings and toppings such as butter and jam.
Start-up
The section of the power cable not in use can be wound up and stored on the base of the appliance.
Connect the power plug to a shockproof socket.
Prior to first use, carry out at least three toasting cycles without bread and at maximum power,
to remove the surface protection on the heating elements. The smell released during this process
is harmless, but you should ensure good ventilation nevertheless. Always allow the appliance to
cool down a little before switching it on.
Insert the toast slices into the toasting slots. To avoid slices becoming jammed, they should not be
thicker than 2,6 cm. Insert small slices upright and next to each other in a toasting slot; this will make
it easier to remove them after toasting.
To begin with set the control knob for the browning degree to medium level. Push down the bread
carriage lever. The appliance switches on and the bread carriage is held down until the appliance
switches off automatically after the toasting time has elapsed. The toasted bread then pops out of the
toasting slot ready for removal.
Notes on the browning level
If the toast is too light in colour, select a higher browning level. If it is too dark, set the control knob
to a lower level. The figures 1 to 7 serve only for orientation purposes. The higher the setting, the
darker the browning level.
The toasting result may vary at the same setting depending on the type, size, moisture and thickness
of the bread slices. Therefore, select a lower setting when toasting less moist bread, smaller slices or
only one slice.
When toasting only one slice, the browning level on the side facing inwards will be slightly more
intensive.
Acrylamide is generated during excessive browning. Excessive browning of the toast should
therefore be avoided.
Interrupting the toasting process
Press the illuminated button
Warming / retoasting
If the warming button is pressed immediately after switching on the appliance,
cold but already toasted bread will be crisped up and too lightly toasted bread
will be slightly retoasted.
Defrosting
If this button is pressed directly after the appliance is switched on, the toast-
ing cycle will be extended automatically to toast frozen bread.
Removing the toast
With the integrated automatic lift mechanism, small slices of bread can also be
removed safely and easily.
10
to interrupt the toasting process.
Bread roll attachment
The toaster is fitted with an integrated roll attachment, which can be used by
pressing the button downwards.
Two rolls can be warmed up from either side on a medium setting in each case.
Rolls which are too dry should be moistened slightly beforehand - it works better
this way.
Crumb tray
Crumbs produced during toasting are collected in the crumb tray.
You can then pull the tray out of the appliance.

Cleaning and maintenance

Before cleaning, disconnect the appliance from the mains and allow the appliance to cool down. Use a
hard brush to remove crumbs sticking to the grids and the heater. Do not tilt the appliance while you
do this, or crumbs will spill from the crumb tray into the inside of the toaster. Then pull out the crumb
tray, clean it and reinsert.
Never immerse the toaster in water. Wipe the outside of the appliance only with a damp cloth and
some washing-up liquid. Do not use harsh or abrasive cleaning agents.
11