GAUI NEX6 Bedienungsanleitung Seite 5

Section 3 - lower frames / Battery mount / Landing Gear / Main Gear
DETAIL C
CORRECT
Thread holes are streight on the same level
WRONG
miss alignment of the M3 thread holes
First deburre all holes of the main mast if neccesary.
Slide in the pre-assembled clutch gear laterally, push the rotor shaft through
from above and secure with M4x23 and M4 lock nuts.
The main mast should have axial play of 1/10 mm or eben less. (up and down)
In case of more free play than 1/10mm add one shim.
Attatch all parts of the lower chassis corresponding to the explosion
drawing. In addition you may use the illustration on left.
Please check the correct position and alignment of the aluminum
brackets No. 1 on the rear and the front as well No. 6.
All thread holes must be aligned in the same hight - see DETAL C
for reference.
Connect the upper mechanic with the lower section using M3x6 /
M3x8 screws.