Warranty Disclaimer - Hama 00201625 Bedienungsanleitung

Note - QC 3.0, 2.0
• Plug & GO: no additional software required,
simply plug in and start:
Thanks to QC 3.0, 2.0, the voltage and power
are adjusted automatically.
• Be aware that, for efficient and optimised
charging, your terminal device must support the
QC 3.0, 2.0 function.
• If you have a large number of QC-enabled
devices with different firmware updates, it may
be that the function is not fully supported.
Warning
• Only operate the product from a socket that has
been approved for the device. The socket must
be installed close to the product and must be
easily accessible.
• Disconnect the product from the power supply
using the On/Off switch – if this is not available,
unplug the power cord from the socket.
• If using a multi-socket power strip, make
sure that the total power consumption of all
connected devices does not exceed the power
strip's maximum throughput rating.
• If you will not be using the product for a
prolonged period, disconnect it from mains
power.
Unless different instructions have been expressly
given in the operating instructions for the devices
you are charging, proceed as follows:
• Connect your device to the USB charging socket
using a suitable USB cable.
• Connect the charger to a properly installed and
easily accessible mains socket.
• The charging process is displayed on your device.
• Disconnect the device from the charger if you wish
to interrupt the charging process or when the
device is fully charged.
• Then disconnect the charger from the line
connection.
When charging the rechargeable batteries in the
device, note the maximum charging times for the
built-in batteries.
5. Care and maintenance
Only use soft, dry towels to clean the product.
Note
Disconnect the device from the mains before
cleaning and during prolonged periods of
non-use.
6. Technical data
Specifications according to
Regulation (EU) 2019/1782
Brand name,
commercial register
number, address
Model identifier
Input voltage
Input AC
frequency
Output voltage /
output current /
output power total
Average efficiency
during operation
Efficiency at low load
(10%)
Power consumption at
zero load

7. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
Hama, HRA12159,
Dresdner Str. 9,
86653 Monheim,
Germany
00201625, 00201626
100 – 240 V
50 / 60 Hz
3.6 – 6.5 V DC / 3.0 A /
10.8 – 19.5 W
6.5 – 9.0 V DC / 2.0 A /
13.0 – 18.0 W
9.0 – 12.0 V DC / 1.5 A /
13.5 – 18.0 W
82.5 %
76.4 %
0.07 W
3