INSTRUCTIONS FOR USE [AE]
2.
Mount the coupler on the rear wheel axle:
-
Remove one of the springs from the quick-release skewer and
insert the quick-release skewer through the coupler.
-
Insert the quick-release skewer into the bicycle axle from the
left side (if looking at the bike from behind) pointing right.
-
Replace the spring back onto the quick-release skewer (The
narrow end of the spring points inwards towards the bike.)
3.
Tighten the connection firmly in order to secure the rear wheel:
-
Tighten the quick-release knob until you can close the clamp
with a certain amount of pressure.
13