SW-Stahl S3211 Bedienungsanleitung Seite 7

M A I N T E N A N C E T I P S
This air hammer requires lubrication BEFORE initial use and BEFORE and AFTER each additional use
throughout its life.
1.
WARNING !!! Disconnect the air hammer from the air supply and hold the tool upside down.
2.
Pull the trigger, put a half teaspoon of air tool oil into the air inlet.
3.
Reconnect the air hammer to the air supply and run the hammer for 20 seconds.
Cover the exhaust port with a towel and run for 20 seconds. Oil will discharge from
the rear exhaust port when air pressure is applied. Any excess oil in the motor is immediately
expelled from the exhaust port.
WARNING !!! Always direct exhaust port away from people or objects.
U T I L I Z AT I O N
A hit chisel to loose the
rusted big parts.
Hit the rivet from joints.
S 3 2 1 1
A R9 chisel for loose the
ball joint connections.
Impact the rusted nut
with the socket.
7