Explanation Of Symbols - 3M BAIR HUGGER 360 Gebrauchsanweisung

6. Gently press the edge of the sensor to ensure good adhesion with the skin.
Optional: Support the sensor cable with the provided sensor cable clip.
7. The control unit will sense patient attachment after several seconds.
8. The patient's temperature will display on the patient monitor once
system equilibrium is reached.
Removing the sensor
1. Disconnect the sensor
cable from the sensor.
Disconnect the sensor
cable clip from the bed or
sheet, if used.
2. Starting at the edge of the
sensor, gently remove the
sensor from the patient
(Figure 4).
Note: Do not use the sensor
tab to remove the sensor
from the patient (Figure 4).
Note: If needed, use an alcohol swab along the edge of the sensor to help
remove the sensor from the patient.
3. Discard the sensor and clean the sensor cable according to institutional
protocol.
Storage/Shelf Life/Disposal
Sensor Shelf Life: 36 months
Storage Conditions:
-20˚C to 60˚C
Store all components at room temperature and in a dry place when not in use.
Dispose of sensor according to institutional protocol.
Please report a serious incident occurring in relation to the device to 3M
and the local competent authority (EU) or local regulatory authority.
For further information, please contact your local 3M representative.

Explanation of Symbols:

Symbol Title
Authorized
Representative
in European
Community
/ European
Union
Catalogue
number
Caution
Symbol Description and Reference
Indicates the authorized representative in
the European Community / European Union.
Source: ISO 15223, 5.1.2, 2014/35/EU, and/
EC REP
or 2014/30/EU
Indicates the manufacturer's catalogue
number so that the medical device can be
identified. Source: ISO 15223, 5.1.6
Indicates that caution is necessary when operating
the device or control close to where the symbol
is placed, or that the current situation needs
operator awareness or operator action in order
to avoid undesirable consequences. Source:
ISO 15223, 5.4.4
Figure 4
5
sensor tab