Product Specifications - Carpoint 05.103.30 Gebrauchsanweisung

PROBLEM
Unit will not operate.
Low Voltage Alarm On Continu-
ously
Low Output Voltage
Television Interference
Buzz or Hum in Audio System
if used

PRODUCT SPECIFICATIONS

continuous power:
surge capability:
input voltage:
output voltage:
ouput frequency:
output waveform:
efficiency:
static current:
low input voltage protection:
low input voltage warning:
output overload protection:
cooling fan:
10330i.indd 3
POSSIBLE CAUSES
Inverter not adequately warmed
up. Be sure the environmental
temperature is above - 10Cº.
Battery voltage is below 10 Volts.
Equipment being operated draws
too much power.
Inverter in thermal shut down
condition.
Battery in poor condition. Have
battery checked.
Insufficient power or large voltage
drop.
Using average reading voltmeter.
Inverter is overloaded.
Input voltage below 11 Volts.
Snow, picture is breaking up.
The power supply in the device
does not adeuately filter the
modified sine wave produced by
the power inverter.
150W
300W
10-15V DC
220~240V AC ±10% related to connected load
50Hz
Filter Modified Sine Wave
>90%
<250mA
10,0±0,5V
10,5±0,5V
180W
yes, starts automatically if necessary
SUGGESTED REMEDY
Turn inverter power switch off and
on until it powers your appliance.
Repeat as necessary until appliance
starts.
Charge or replace battery.
Reduce load under the maximum
watts.
Inverter must cool down. Check for
good ventilation. Make sure load is
less than max continuous power.
Replace battery.
Check condition of alligator clips.
Clean or replace as necessary.
True RMS reading meter
Reduce load under the continuous
watts to maintain regulation.
Keep input voltage above 11 volts
to maintain
a) Locate the power inverter as
far as possible from television, the
antenna, and the antenna cables.
b) Adjust the orientation of the
power inverter antenna cables,
and TV power cord to reduce
interference.
c) Make sure that the antenna
feeding the television provides an
adequate ("snow free") signal and
that high quality, shielded antenna
cable is used.
Use a sound system that uses a
higher quality power supply
3
15-02-2007 16:03:5