Assembly Instructions; Place The Control Column In The Control Column - Hedson IRT-401 XLNC Bedienungsanleitung

4.

Assembly Instructions

Begin by screwing the wheels into the base. Posi-
4.1
tion the lockable wheel at the back. Screw the
control column socket into the base.
Note! For the time being, tighten only by hand. To
facilitate assembly, actuate the brake on the braked
wheel.

Place the control column in the control column

4.2
socket.Tighten all the screws. Fit the handle.
Fit the supporting arm and the round plates into the
4.3
control column, lower arm first. The parallel arm in
the raised position. After a period of use it may be
necessary to re-tighten the four bolts of the parallel
arm.
Fit the yoke and the cassettes.
4.4
4
IRT-401/402 XLNC, 230V, 400 V, 1Ph, 3Ph
M10x70
N.B. Tighten the attached
locking nuts inside the
cassette
M 10 (lock)
Cable backwards
M8x65(2x)
M10x130
Large washer
M12x65(2x)
M10x60
Tools
M10x40(8x)
M12 x 160