Technical Data; General Power Tool Safety Warnings - Max 31131 Gebrauchsanweisung

CIRCULAR
BENCH SAW
Introduction
To get the most out of your new circular
bench saw, please read through these
instructions before use. Please also keep the
instructions in case you need to refer to
them at a later date.

Technical data

Voltage/frequency:
Power rating: S1 1800 W, S6 25% 2000 W
Speed:
Saw blade:
Cutting depth at 90/45°:
Bevel angle:
Bench size:
Sound level Sound level
Sound pressure, L : 94.0 dB(A), K
pA
Sound level, L , L : , L
WA WA
48
220-240 V~ 50 Hz
5000 rpm
Ø250xØ30x2.8 mm
Max. 85/65 mm
0-45°
893x583 mm
: 3 dB(A)
pA
107.0 dB(A), K : 3 dB(A)
WA
General Power Tool
Safety Warnings
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains operated (corded) power tool or batte-
ry-operated (cordless) power tool.
Work area safety
Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
Keep children and bystanders away while opera-
ting a power tool. Distractions can cause you to
lose control.
Electrical safety
Power tool plugs must match the outlet. Never mo-
dify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools. Unmo-
dified plugs and matching outlets will reduce risk
of electric shock.
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and refri-
gerators. There is an increased risk of electric shock
if your body is earthed or grounded.
Do not expose power tools to rain or wet conditi-
ons. Water entering a power tool will increase the
risk of electric shock.
Do not abuse the cord. Never use the cord for car-
rying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges and moving
parts. Damaged or entangled cords increase the
risk of electric shock.
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.