Water Drainage - Tectro Td 210 Gebrauchsanweisung

Fig. 5
Fig. 6: Do not block water
flow by a rise
Fig. 7: Do not block water
flow by a retortion
4
56
¡ ¢ £ ¤ ¥ ¦ § ¨ ©  § §    ¢   ! 

WATER DRAINAGE

When the water container is full, the
will restart.
If desired, it is possible to connect a drainage hose to the device for permanent water
Continuous draining
Remove the rubber plug from the back of the unit (fig. 5a) and store it in a safe
1
location.
Attach the water hose to the drain hose outlet of the unit (fig. 5b). Make sure the
2
connection of the water hose and the drain hose outlet of the unit is tight and does
not let the water leak.
3 Then lead the water hose to the floor drain or a suitable drainage facility. The
drainage facility should be lower than the drain outlet of the unit.
Be sure to run the water hose sloping downward and let the water flow out
4
smoothly. Do not install the water hose as shown (fig. 6 + 7).
When the continuous drain feature is not being used remove the drain hose from
5
the outlet and attach the rubber plug back to the drain outlet.
CLEANING
Switch the dehumidifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
THE AIR FILTER
1
remove the filter (fig. 8 + 9).
2
-light switches on and the dehumidifier switches
¦   ¨   § § §   ¨