The Name Of Each Part; Using The Product - CeraGem CGM EMT-SS1201 Bedienungsanleitung

1. The name of each part

Controller
Power Switch
Mat
Connector
4
Setting temperature and
current temperature
Temperature Control Dial
Main Body

2. Using the product

1. Connect the connector
1. Connect the temperature controller connector to that of
the mat's main body.
- Both grooves must match for connection.
2. Connect the power cord
1. Connect the power cord to the socket.
- This product is used only for AC220V-240V, 50/60Hz.
Before connecting the cord, be sure to check.
※ Do not use loose socket or damaged power code.
3. Use the temperature
1. Connect the power cord and press the power switch on the
controller
controller to turn power on.
2. Pressing the power switch sets the 8-hour timer automatically;
the setting temperature appears on the temperature display for
3 seconds, and then changes to the current temperature.
3. After 8 hours, the temperature controller turns off automatically.
4. How to control
1. After pressing the power switch, fix the temperature control
the temperature
dial to the desired temperature. The setting temperature then
appears on the temperature display.
(Temperature - : 30℃ / + : 65℃)
5. When the product is
1. Press the power switch once again to turn power off.
not in use
2. Be sure to disconnect the power cord from the socket
when the product is not in use.
1. In case of abnormal overheat (65℃) while the mat is in use,
6. Error messages
"th" appears on the temperature display and starts blinking.
2. In case abnormal or short-circuited heating wire occurs while the mat
is in use, "SE" appears on the temperature display and starts blinking.
3. In case of open heating wire while the mat is in use,
"--" appears on the temperature display and starts blinking.
Extended period of use at high temperature poses risk of burns.
Be sure to set the dial to "-" when using the product for an extended period.
Caution
5