The Name Of Each Part; Using The Product - CeraGem CGM EMT-MS1202 Bedienungsanleitung

1. The name of each part

Controller
Power Switch
Mat
Main Body
4
Setting temperature and
current temperature
Temperature Control Dial
Grip
Connector

2. Using the product

1. Connect the connector 1. Connect the temperature controller connector to that of the
mat's main body.
- Both grooves must match for connection.
2. Connect the power cord
1. Connect the power cord to the socket.
- This product is used only for AC230V, 50Hz.
Before connecting the cord, be sure to check.
※ Do not use loose socket or damaged power code.
3. Use the temperature
1. Connect the power cord and press the power switch on the
controller
controller to turn power on.
2. Pressing the power switch sets the 12-hour timer automatically;
the setting temperature appears on the temperature display for
3 seconds and then changes to the current temperature.
3. After 12 hours, the temperature controller turns off automatically.
4. How to control the
1. After pressing the power switch, fix the temperature control dial
temperature
to the desired temperature. The setting temperature then appears
on the temperature display.
(Temperature - : 30℃ / + : 65℃)
5. When the product is not 1. Press the power switch once again to turn power off.
in use
2. Be sure to disconnect the power cord from the socket when
the product is not in use.
1. In case of abnormal overheat (65℃) while the mat is in use, "th"
6. Error messages
appears on the temperature display and starts blinking.
2. In case abnormal or short-circuited heating wire occurs while the mat
is in use, "SE" appears on the temperature display and starts blinking.
3. In case of open heating wire while the mat is in use, "--" appears
on the temperature display and starts blinking.
Extended period of use at high temperature poses risk of burns.
Be sure to set the dial to "-" when using the product for an extended period.
Caution
5