clearaudio electronic nano phono V2 Bedienungsanleitung Seite 8

User manual / Bedienungsanleitung
3. Troubleshooting
If you have a problem with your
operation.
If the error persists, please contact your dealer!
Never try to open the device and/or repair it yourself, this will void the warranty!
Error
Device does not work
No sound or
low volume?
Hum or
noise
One channel quieter or
louder
Remote control
does not work
Page / Seite 8
nano phono V2
Cause
Is the power cord plugged in and the power
switch turned on?
Did you choose the right input?
Have you selected the correct operating
mode?
Is the device in „mute" mode or is the
volume set too low?
The connection cables are not properly
connected.
Devices with a headphone output only:
Are the headphones still plugged in when
you are trying to play music through the
speakers?
The ground cable is not connected or is
faulty.
The device should not be operated in the
vicinity of high-frequency devices such as
mobile phones or modems or on power
supply systems used for data traffic (PLC).
The channels of an input are set differently. Check the settings on the underside of the
The sensor of the phono stage is covered.
You are out of range of the receiver.
The battery of the remote control is
exhausted.
, first check the possible causes to rule out incorrect
Check the connection.
Check the connections of your hifi
components.
Check the settings on the underside of the
phono stage.
Check the volume setting of your device.
Check
connections due the their respective user
manual.
Disconnect the headphones.
Connect the grounding cable from the
turntable/tonearm
grounding connection on the back of
the device. If there are several ground
connections, interrupt them one after the
other and check the sound quality again.
Make sure there is a minimum distance of
30cm between the power supply units of
any type and the MC preamplifier or phono
preamplifier. Powerlan adapters should not
be operated on the same socket as the
phono preamplifier.
phono stage. These must be carried out
identically for an input.
Do not place any other objects in front of
the phono stage, as these could interfere
with reception.
Get closer to the device.
Replace the battery as described in this
user manual.
© clearaudio electronic GmbH, 2022-10
Measure
the tonearm and cartridge
to the respective