clearaudio electronic nano phono V2 Bedienungsanleitung Seite 6

User manual / Bedienungsanleitung
2. Setup
nano phono V2
1. The
cartridges. Cartridge type is selected with individual jumpers for the left and right channels which
are located on the underside of the unit.
Select either the MC (moving coil) or MM (moving magnet) mode according to your cartridge type,
by inserting the removable jumpers into the relevant positions on the bottom of the unit (one each
for left and right channels).
The standard input impedance is set at 47kΩ, which ensures an optimal setting for all MM cartridges.
For the perfect input matching with MC cartridges, Clearaudio includes the following resistor pairs:
Pic. 2: Colour codes of the resistors
If there are no resistors connected to the jumpers while in MC mode, the cartridge is automatically
loaded with 47kΩ.
The 402Ω resistors are recommended for Clearaudio MC cartridges.
The other resistor values allow 3rd party MC cartridges to be loaded according to the manufacturer's
guidelines. It should be noted that sometimes your personal preference for cartridge loading may
differ from that recommended by the cartridge manufacturer.
If so, Clearaudio recommends: Trust your own listening abilities, in your own surroundings!
2. The subsonic-filter function can also be adjusted by inserting jumpers into the relevant points
on the bottom of the unit.
Pic. 3: View from the bottom side
Page / Seite 6
is a fully Dual Mono Design, designed for use with either MM or MC
If the jumper is inserted, then the subsonic filter is OFF.
If the jumper is not inserted, then the subsonic filter is
ON.
© clearaudio electronic GmbH, 2022-10