Max PJRC160 Betriebsanleitung Seite 8

• Follow all charging instructions and do
not charge the battery pack or tool out-
side the temperature range specified in
the instructions. Charging improperly or
at temperatures outside the specified
range may damage the battery and in-
crease the risk of fire.
• Lithium-ion batteries have shipping re-
strictions. For transportation, please con-
tact the transportation company or airline
in advance.
6. SERVICE
• Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
• Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or author-
ized service providers.
3. REBAR CUTTER SAFETY
WARNINGS
1. KEEP HANDS AWAY FROM MOVING
PARTS
2. BE SURE TO KEEP HANDS AWAY FROM
THE TRIGGER SWITCH AND DETACH
THE BATTERY PACK WHEN REPLACING
THE BLADE, WHEN ABNORMALITIES
OCCUR, AND WHEN THE EQUIPMENT IS
NOT BEING USED
Leaving the Battery pack installed in these sit-
uations may cause breakdowns or damage.
3. NEVER MODIFY THE TOOL
Modifying the tool will impair performance and
operating safety. Any modification may lead to
serious injury and void the tool warranty.
4. MAINTAIN THE TOOL IN GOOD OPERAT-
ING CONDITION
(CHECK TIGHTNESS OF SCREWS BE-
FORE OPERATION)
To secure operating safety and ensure top
performance, keep the tool free of wear and
damage.
Under normal operation, the tool is designed
to produce vibration. Due to the vibration, the
screws can come loose, causing damage to
the tool or serious injury.
Also keep the tool's hand grip dry and clean,
especially free of oil and grease.
5. LET THE TOOL WARM UP FOR SEVERAL
MINUTES BEFORE USE
In cold weather or when the tool has not been
used for a long period of time, the internal lu-
brication in the tool might not be insufficient.
In such cases, let the tool warm up for several
minutes by operating it with no load. Lacking
sufficient internal lubrication, the tool might
not operate at full performance.
6. MAKE SURE THERE IS NO ONE BELOW
WHEN USING THE TOOL IN HIGH LOCA-
TIONS
Failure to do so may lead to serious injury of
the person below.
8