Unitec W194-1 Bedienungsanleitung Seite 21

TIME
G ) NETWORK TIME (Auto-synchronized clock)
1
The clock on the main unit is synchronized to the
Internet network time automatically and is adjusted
for optimal accuracy.
Note:
• If your PC is not connected to the Internet for a
long period of time, the clock display may not be
accurate.
• You may set the time offset (+/– 0.5, 1, 1.5 or 2
hours) of your home city in the PC program to
adjust DST & time zone if necessary and the time
on your main unit will be updated accordingly.
Hold [CLOCK] 3 on the main unit to set the 12/24
hour format, press [s] 5 or [t] 6 to select and
press [CLOCK] to conirm. The "M" & "D" icons will
lash, press [s] 5 or [t] 6 to select day/month or
month/day format for the calendar. Press [CLOCK] 3
to conirm and exit.
G ) SUNRISE / SUNSET TIME
2
To view the sunrise and sunset time of your home
city, press [CLOCK] 3 button repeatedly until the
respective "SUNRISE" or "SUNSET" icon appears.
G ) ALARM TIME
3
Press [ALARM] 4 button to view the alarm time
and "AL" icon will appear. Press [ALARM] 4 again to
enable & disable the alarm. " " icon appears when
alarm is enable. Press [CLOCK] 3 to return to time
display.
Hold [ALARM] 4 for 3 seconds to enter alarm set-
ting mode. Press [s] 5 or [t] 6 to enter the desi-
red Hr/ Min values and press [ALARM] 4 to conirm
setting. When alarm is going off, press [ALARM] 4
to stop alarm for one day. Press [MODE/SNOOZE/
LIGHT] 1 to activate snooze function
H) MOON PHASE
Moon phase is displayed according to the current
calendar automatically.
I) CALENDAR
Press [CLOCK] 3 repeatedly to show the time with
day-of-the-week or seconds.
Calendar can be displayed in day/month or month/
day format. See section A "NETWORK TIME" for
setting.
313500.00_W194-1_Manual.indd 21
DISPLAY BACKLIGHT
Press MODE/SNOOZE/LIGHT 1 for an extended
(G) Network Time or
backlight.
Sunrise + Sunset
Time or
LOW BATTERY INDICATION
Alarm Time
Low battery indication is available for the main unit
(H) Moon Phase
& USB transmitter. Replace the batteries and follow
the setup procedure in this instruction manual.
(I) Calendar
Low battery indicator
Main unit:
USB transmitter: Below to the "Last Update" box
Remote sensor: Next to the "CH 1 2 3" icons
Note:
After battery replacement, you are required to set up
the RF connection again.
Main Unit & USB Transmitter: Press [PC Search] 2
on main unit, then press [TRANSMIT] 9 on USB
transmitter.
Main Unit & Remote Sensor: Hold [CH/SEARCH] 7
on main unit, then press [TX]  on remote sensor.
Refer "ESTABLISH RF CONNECTION WITH MAIN
UINIT" section for details.
USB TRANSMITTER
Press [PC Search] 2 on the main unit and then
press [TRANSMIT] 9 on the USB transmitter to
enforce transmitting RF weather data and set up
the RF connection with the main unit. (See "USB
TRANSMITTER & PROGRAM INSTALLATION"
section to set up the USB transmitter).
Note:
• To run the PC program, ensure that your USB
• When weather data is transmitted from the USB
21
Below the "IN"-icon in local section
transmitter is connected properly to the PC via an
USB port.
transmitter, the red LED  will lash.
English
15.06.12 11:19