Mounting The Tonearm Base; Mounting The Tonearm Base On The Clearaudio Performance Dc Or Ovation Turntable - clearaudio electronic Tracer Bedienungsanleitung

User manual / Bedienungsanleitung

2. Mounting the tonearm base

2.1 Mounting the tonearm base on the Clearaudio Performance DC or Ovation turntable

Please check if the correct tonearm base is mounted on your turntable (Pic. 2).
Please note that you will need an different tonearm base, if you want to mount the
in combination with the VTA-Lifter (Pic. 3).
If the wrong tonearm base is mounted place the turntable on the edge of a table or similar surface
to gain access to the tonearm base from below.
Remove the tonearm base by loosening the six M4 x 35mm screws with a hex wrench on the bottom
side of the clamping ring.
Exchange the tonearm base and loosely tighten the screws to keep the tonearm base rotatable.
Please ensure the perfect location of the base.
Pic. 2: Tonearm base for Performance DC &
Ovation without VTA-Lifter (Art. No. AC031-4)
Pic. 3: Tonearm base for Performance DC &
Ovation with VTA-Lifter (Art. No. AC031-8)
Made in Germany
Without VTA-Lifter
To mount the tonearm without VTA-Lifter, you need the tonearm base
AC031-4 (Pic. 2)
With VTA-Lifter
To mount the tonearm in combination with VTA-Lifter, you need the
tonearm base AC031-8 (Pic.3).
Tracer
tonearm
Page / Seite 7