Dust bag
When the dust bag is full, replace it with a new one according to the
bag every 6-8 weeks.
Open the cover
*Note: The fastener seals the dust and debris in the dust bag.
Cleaning the dust tunnel
①
The dust bag indicator light is solid green, but the dust bag is
not full, unplug the dust collector, turn the dust collector over, use
a screwdriver to remove the screws as shown in the fi gure and
open the dust duct cover to clean out the foreign objects.
②
Open the air outlet at the rear of the dust collector, clean the
sponge fi lter, and then put it back in.
*Do not disassemble by force, use a screwdriver to remove the
screws. Reassemble it according to the original design after each
clean.
Pull up the dust bag
Throw away the old
through its handle
Dust bag indicator (solid green light).It is recommended to replace the dust
Replace with a
dust bag
new dust bag
Dust tunnel cover
Sponge fi lter
Close the fl ip cover