TEKNIHALL AF2 Original Bedienungsanleitung Seite 47

NOTE!
The fan and heating element are located at the top, inside in the slot
of the hot air fryer. Clean this area very carefully.
2. Wipe the inside and outside of the slide-in unit 1 and the draining
board 3 with a damp cloth.
Setting up and heating up the appliance for the first time
Set up the appliance on an easily accessible, level, dry, heat-resistant
appliance ensure a secure hold.
Maintain a minimum distance of 30 cm from the rear of the appliance
to other objects and at least 10 cm to each side.
1. First place the draining board 3 at an angle
into the base of the slide-in unit 1 (under
the lower screws) and then press it down.
Pay attention to the markings 1a and 3a.
2. Push the slide-in unit 1 with the
inserted draining board 3 into the
hot air fryer.
3. Connect the power plug to a socket.
All symbols in the control panel 7 will
remain active.
4.
200°C (392°F) and the time min (15) will be shown.
Risk of damage!
15
3a
3
1a
1
10 will