Operation - Panasonic EY46A2 Bedienungsanleitung

Attaching or Removing
Battery Pack
CAUTION
Before inserting battery pack, check that
the power switch on the tool actuates
properly and returns to the "OFF"
position when released.
1. To connect the battery pack:
Align the highlighted marker points
and attach battery pack.
• Slide the battery pack until it locks
into position.
2. To remove the battery pack:
Push down the button and slide the
battery pack forward.
01_Eng_EY46A2(EU).indd 11
IV. OPERATION
Power switch operation
• Before inserting the battery pack
into the tool, always make sure that
the power switch operates properly
and returns to the "OFF" position
when the rear of the power switch is
depressed.
• Power switch can be locked in "ON"
Alignment
position. Stay alert when locking tool
marks
in "ON" position and grasp the tool
firmly using support handle and grip.
Button
- 11 -
NOTE:
Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
CAUTION
To start operation, press and slide the
power switch toward the "ON" position.
For continuous operation, press the
front of the power switch to lock it.
To stop the tool, press the rear of the
power switch, then it returns to the
"OFF" position.
2014/07/02 12:01:21