Cleaning, Maintenance, Storage And Transport - Zgonc 410-33 Originalbetriebsanleitung

Cracks due to the insulation ageing.
•
Such damaged electrical connection cables
must not be used and are life-threatening due
to the insulation damage.
Check the electrical connection cables for
damage regularly. Make sure that the con-
nection cable does not hang on the power
network during the inspection.
Electrical connection cables must comply
with the applicable VDE and DIN provi-
sions. Only use connection cables with
the marking „H05VV-F".
The printing of the type designation on the
connection cable is mandatory.
AC motor
The mains voltage must be 230 V~
•
Extension cables up to 25 m long must
•
have a cross-section of 1.5 mm
Connections and repairs of electrical
equipment
may only be carried out by an electrician.
Please provide the following information in
the event of any enquiries:
Type of current for the motor
•
Machine data - type plate
•
Machine data - type plate
•
10. Cleaning, maintenance,
storage and transport
m Important!
Pull out the power plug before doing
any cleaning and maintenance work on
the equipment. Risk of injury from elec-
tric shock!
m Important!
Wait until the equipment has cooled
down completely! Risk of burns!
m Important!
Always depressurize the equipment before
carrying out any cleaning and mainte-
nance work! Risk of injury!
10.1 Cleaning
Keep the equipment free of dirt and dust
•
as far as possible. Wipe the equipment
with a clean cloth or blow it down with
compressed air at low pressure.
All manuals and user guides at all-guides.com
.
2
We recommend that you clean the
•
equipment immediately after you use it.
Clean the equipment regularly with a
•
damp cloth and some soft soap. Do not
use cleaning agents or solvents; these
may be aggressive to the plastic parts in
the equipment. Ensure that no water can
get into the interior of the equipment.
You must disconnect the hose and any
•
spraying tools from the compressor be-
fore cleaning. Do not clean the compres-
sor with water, solvents or the like.
10.2 Maintenance work on the pressure
vessel (fig. 3)
m Important! To ensure a long service life
of the pressure vessel (2), drain off the con-
densed water by opening the drain valve (1)
each time after using. Release the vessel
pressure first (see 10.3.1).
Open the drain screw by turning counter-
clockwise (looking at the screw from the
bottom of the compressor) so that all the
condensed water can run out of the pres-
sure vessel. Then close the drain screw
again (turn it clockwise). Check the pres-
sure vessel for signs of rust and damage
each time before using. Do not use the
compressor with a damaged or rusty pres-
sure vessel. If you discover any damage,
then please contact the customer service
workshop.
10.3 Storage
m Important!
Pull out the mains plug and ventilate the
equipment and all connected pneumatic
tools. Switch off the compressor and
make sure that it is secured in such a
way that it cannot be started up again
by any unauthorized person.
m Important!
Store the compressor only in a dry loca-
tion which is not accessible to unau-
thorized persons. Always store upright,
never tilted!
GB 21