Proper Use; Safty Instructions - Zgonc 410-33 Originalbetriebsanleitung

4. Proper use

The compressor is designed to gener-
ate compressed air for compressed-air
driven tools which can be driven with an
air volume of up to approx. 170 l/min (e.g.
tire inflator, blow-out pistol and paint spray
gun). Due to the limited air output it is not
possible to use the compressor to drive
tools with very high air consumption (for
example orbital sanders, rod grinders and
hammer screwdrivers).
The equipment is to be used only for its
prescribed purpose. Any other use is
deemed to be a case of misuse. The user
/ operator and not the manufacturer will
be liable for any damage or injuries of any
kind caused as a result of this.
Please note that our equipment has not
been designed for use in commercial,
trade or industrial applications. Our war-
ranty will be voided if the equipment is
used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Safety instructions
m Attention! The following basic safety
measures must be observed when using
electric tools for protection against electric
shock, and the risk of injury and fire. Read
all these notices before using the electric
tool and keep the safety instructions for
later reference.
Safe work
1 Keep the work area orderly
– Disorder in the work area can lead to
accidents.
2 Take environmental influences into ac-
count
– Do not expose electric tools to rain.
– Do not use electric tools in a damp
or wet environment. There is a risk of
electric shock!
– Make sure that the work area is well-
illuminated.
– Do not use electric tools where there
is a risk of fire or explosion.
All manuals and user guides at all-guides.com
3 Protect yourself from electric shock
– Avoid physical contact with earthed
parts (e.g. pipes, radiators, electric
ranges, cooling units).
4 Keep children away
– Do not allow other persons to touch
the equipment or cable, keep them
away from your work area.
5 Securely store unused electric tools
– Unused electric tools should be stored
in a dry, elevated or closed location
out of the reach of children.
6 Do not overload your electric tool
– They work better and more safely in
the specified output range.
7 Wear suitable clothing
– Do not wear wide clothing or jewellery,
which can become entangled in mov-
ing parts.
– Rubber gloves and non-slip shoes are
recommended when working out-
doors.
– Tie long hair back in a hair net.
8 Do not use the cable for purposes for
which it is not intended
– Do not use the cable to pull the plug
out of the outlet. Protect the cable
from heat, oil and sharp edges.
9 Take care of your tools
– Keep your compressor clean in order
to work well and safely.
– Follow the maintenance instructions.
– Check the connection cable of the
electric tool regularly and have it
replaced by a recognised specialist
when damaged.
– Check extension cables regularly and
replace them when damaged.
10 Pull the plug out of the outlet
– During non-use of the electric tool or
prior to maintenance and when re-
placing tools such as saw blades, bits,
milling heads.
11 Avoid inadvertent starting
– Make sure that the switch is switched
off when plugging the plug into an
outlet.
12 Use extension cables for outdoors
– Only use approved and appropriately
identified extension cables for use
outdoors.
GB 17