Introduction; Layout; Scope Of Delivery - Zgonc 410-33 Originalbetriebsanleitung

1. Introduction

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschine
GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much
enjoyment and success.
NOTE:
According to the applicable product liability
laws, the manufacturer of the device does
not assume liability for damages to the
product or damages caused by the product
that occurs due to:
• Improper handling,
• Non-compliance of the operating in-
structions,
• Repairs by third parties, not by author-
ized service technicians,
• Installation and replacement of non-orig-
inal spare parts,
• Application other than specified,
• A breakdown of the electrical system
that occurs due to the non-compliance
of the electric regulations and VDE regu-
lations 0100, DIN 57113 / VDE0113.
WE RECOMMEND:
Read through the complete text in the
operating instructions before installing and
commissioning the device. The operating
instructions are intended to help the user
to become familiar with the machine and
take advantage of its application possibili-
ties in accordance with the recommenda-
tions. The operating instructions contain
important information on how to operate the
machine safely, professionally and econom-
ically, how to avoid danger, costly repairs,
reduce downtimes and how to increase reli-
ability and service life of the machine.
In addition to the safety regulations in the
operating instructions, you have to meet
the applicable regulations that apply for the
operation of the machine in your country.
16 GB
All manuals and user guides at all-guides.com
Keep the operating instructions package
with the machine at all times and store it
in a plastic cover to protect it from dirt and
moisture. Read the instruction manual each
time before operating the machine and
carefully follow its information. The ma-
chine can only be operated by persons who
were instructed concerning the operation of
the machine and who are informed about
the associated dangers. The minimum age
requirement must be complied with.
2. Layout (Fig. 1,2)
Drain plug for condensation water
1.
Pressure vessel
2.
Wheel
3.
Supporting foot
4.
Quick-lock coupling (regulated com-
5.
pressed air)
Pressure gauge (for reading the preset
6.
vessel pressure)
Pressure regulator
7.
ON/OFF switch
8.
Transport handle
9.
A Hex bolt
B Nut
C Washer
D Flange nut
E Holder

3. Scope of delivery

Open the packaging and remove the
•
device carefully.
Remove the packaging material as
•
well as the pack aging and transport
bracing (if available).
Check that the delivery is complete.
•
Check the device and accessory parts
•
for transport damage.
If possible, store the packaging until
•
the warranty period has expired.
ATTENTION
The device and packaging materials are
not toys!
Children must not be allowed to play with
plastic bags, film and small parts! There is
a risk of swallowing and suffocation!