A&D GC-Serie Kurzanleitung Seite 9

Counting mode
Preparing counting mode
Enter the mass value (unit weight) per product before using counting mode.
Step 1. Turn on the display using the ON/OFF key.
Or, press the RESET key to clear unit weight after turning on the display.
Step 2. The three LEDs blink. The method to enter unit weight can be selected. The
counting mode becomes the initial state.
Step 3. Press one of the keys below to select the method to enter unit weight or recall it
from memory.
If you lose your place during operations or want to stop the current
NOTE
operation, press the RESET key. Tare and total values, comparator
settings are kept.
"1.1. Detailed
Refer to
※
a sample.
Unit weight by samples
Counting mode with using 10 samples
Step 1. Press the RESET key to clear unit weight.
The three LEDs of "UNIT WEIGHT BY" blink.
Place a tare (container) on the center of
weighing pan.
Step 2. Press the SAMPLE key.
The scale subtracts tare weight (container
weight) from weighing value and displays
If zero is not displayed, press the TARE key.
English (EN)
Unit weight by weighing a sample is entered.
Unit weight by using numeric key is entered.
Unit weight from memory is recalled.
manual" for methods of setting the unit weight other than from
and pcs automatically.
Clear unit weight
Tare (container)
(If zero is not displayed
Zero display
9
)