Before Using The Device; Using The Device; Maintenance And Cleaning - Parkside PSTS 12 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

 Before using the device
1. Fit the connector
2. Depending on the height required, fi t the short socket pipe
the connector (see Fig. G + H).
5
3. Select one of the fountain attachments
4. You can change the shape of the fountain with the modifi ed attachment
attachments –
11
5. Connect the pump cable
tighten the lock handtight (see Fig. J).
PLEASE NOTE: Prevent the pump from running dry. Failure to do so will void any warranty and
liability claims.
 Using the device
Check whether the position for the pump

surface before you use it. For smooth supporting surfaces, you can use the suction pads on the
underside of the pump
Position the pump

Align the pump
1
Do not place the pump

raised, such as, for example, on a stone.
Never use the pump

would damage the pump
In order to achieve the very best pumping results, the pump

Only allow the pump

If you use the pump

sand as possible.
Now position the solar panel

stands can be folded out or alternatively, the solar panel
16
provided for this purpose.
17
PLEASE NOTE: In order to achieve the maximum water fl ow, the solar panel
positioned in an area with direct, all-day sunlight and not in shadow.
PLEASE NOTE: You can position the pump
of the water. The selected fountain attachment
even where there are light waves, so that the jet spouts properly.
 Maintenance and cleaning
The pump has been manufactured in a reliable, high-quality design, where the non-contact pump
1
wheel mechanism ensures a long period of operation. However the fan wheel unit
contamination from the operating environment and must not be damaged.
CAUTION: In order to clean the pump
from the solar panel
4
10 GB/IE/NI
onto the nozzle
5 19
6
(see Fig. B3).
13
to the cable of the solar panel
14
to do this.
1
fully below the surface of the water, ideally at least 4 cm under the water level.
1
so that it is as level and horizontal as possible.
directly onto slimy or sandy surfaces. The ideal position is for it to be
1
without the fi lter grille
1
.
1
to operate when it is completely submersed in water.
1
in an ornamental pond, position the pump
1
in such a way that it is in full sunlight. For better alignment, the
4
fi rst. There is a risk of electric shock or risk of injury through moving parts.
of the pump , as shown in Fig. F.
1
3
– and fi t it onto the socket pipe
10
15
is secure and fi x the pump
1
. This prevents the ingress of coarse dirt which
21
1
4
to a depth of approx. 17 cm below the surface
1
– must always be above the surface of the water,
6 10
or carry out maintenance work, always disconnect it
1
or one or more socket pipes
(see Fig. I).
2
with one of the fl at
9
. To do this connect the two plugs and
onto the supporting
1
must be positioned on a fl at surface.
in an area which is as free of
1
can be fi tted to the suspension holes
should be
4
is susceptible to
18
onto
2