Foscam 305503000664 Benutzerhandbuch Seite 11

All manuals and user guides at all-guides.com
STEP 4:
Remove the existing doorbell button near the front door. Pull the two wires out carefully
when removing the old doorbell. Straighten the wire end if necessary.
What is required: Dual-purpose screwdriver
STEP 5:
Determine the mounting position of the doorbell. First check if you can reuse the
existing holes in the wall. Use the drill hole position template to mark the screw holes in
the area where the existing doorbell button was located. Place the drill hole position
template at least 1.5m (59") high from the ground to ensure that the height of the
installed doorbell will be suitable, and then drill the holes (use PH2 drill bit).
11