Werbung
English
1. Parts list.
2. Insert A-H31R at the end of part A-H11R, then connect A-H11R to A-H7 and A-H13.
3. Note: Do not tighten the nut now.
4. Note: Do not tighten the nut now.
5. Slide the two buttons in the grooves of parts A-H8L and A-H8R.
6. insert the end of A-H8R to the bolt, turn the bolt to insert in the groove then tighten the nut.
7. Connect and fix A-H15 to A-H11 on the triangular part A-H30 with the bolt and the nut.
8. Insert the end of part A-H9 into the bolt, turn the bolt to insert in the groove then tighten the nut.
9. Note: Do not tighten the nut now.
10. Install the plastic part A-H32 in the direction shown on the picture.
11. Slide A-H24 in the groove of the A-H18.
12. Adjust A-H28 in the appropriate position then tighten with the bolt and the nut.
13. Insert polycarbonate panel A-H40 into the groove of A-H4
14. SILICONE SEALANT
15. GLUE GUN
16. NOTE: Silicone sealant and glue gun are not included and must be purchased locally.
17. Tip: glue parts A-H9 & A-H10 carefully. Install the polycarbonate panels in the correct position.
18. Fix part A-H32 which is located at the bottom of the door, in part A-H6.
19. Profile A-H22 pass through the A-H32 which on the top of door, then adjust it to the middle
position.
20. Use the "W" clip to fix the PC sheet with the profile as shown
21. Adjust A-H32 in order to smooth sliding the door.
22. Make one end of clip into the gloove and make it support to the profile, then force the other
end make the clip tensional, put the other end into the groove.
23. Rear
24. Front
25. Note :
26. Remove approximately 2 inches of film from all sheet edges before installing. remove all film
immediately after the constructions completed.
27. The UV-protected side of the sheet is covered with opal white film and must face towards the
sun.
28. Two sides of PC sheet are covered with thin film, one side's film is transparent, another side's
film is opal white.The UV-protected side of the sheet is covered with opal white film and must face
towards the sun.
Werbung
