N'oveen PTC2000 SMART Benutzerhandbuch Seite 12

5. Press the (2) button to select one of the operating modes:
- Heating I (low power)
- Heating II (high power)
6. To distribute the airflow over a larger area, press the oscillation button (5). The device begins to
swing left and right. To stop the device in the desired position, simply press the oscillation button (5)
again.
7. To turn off the device, press the (1) button. The display may show a countdown for approximately
30 seconds (cooling mode).
ECO FUNCTION (PTC3000)
To activate this function, press the ECO button (4). The ECO icon will be displayed.
The ECO function allows you to automatically reach the set temperature in the range of 15-35 . ℃
Press (6) to increase the desired temperature or (7) to decrease it.
The device will compare the set temperature with the current room temperature and will automatically
select the most appropriate heating level to guarantee the optimal level of comfort while reducing
energy consumption. When the ECO function is turned on, the machine can
automatically switch to a lower or higher heating level, even several times.
The appropriate heating level is always shown on the display.
DIGITAL 24 HOUR TIMER (PTC3000)
This function can be activated from any operating mode.
With the device turned on, press the Timer button (3). The timer icon is displayed together with
time remaining until the device is turned off. To set the timer (1 - 2 - 3 -... - 24 Hours), use
the + (6) and - (7) buttons, and then wait a few seconds for the setting to be memorized
(the value stops flashing for 2 seconds before it is stored).
When finished, the timer icon is displayed during normal operation to indicate that the timer
has been set. After reaching the programmed time, the device switches off automatically.
To return to work without a timer, press the timer button twice. The timer icon disappears from the
display.
Caution:
1. Before removing the plug from the socket, turn the device off and wait 30-60 seconds.
During this time, the fan will blow air to cool internal parts. By not allowing to cool the device
down before switching off, you may expose it to permanent damage.
2. The remote control uses CR2025 batteries.
12