N'oveen PTC2000 SMART Benutzerhandbuch Seite 10

indicated on the product identification plate.
2. Remove the unit from its packaging and check to make sure it is in good condition before using.
3. Do not let children play with parts of the packing (such as plastic bags)
4. Close supervision is necessary when the product is used by or near children or infirm persons. Do
not allow children to use it as a toy.
5. Do not operate any product with a damaged cord or plug, or after the product malfunctions, or is
dropped or appears damaged in any way.
6. In case of a mulfunction, make contact with service center.
7. Before unplugging the power cord, be sure to turn the power off. When touching the unit, be sure
your hands are dry to prevent electrical shock.
8. Ensure the cord is fully extended before use and arrange it so that it is not in contact with any part
of the heater.
9. In use, some parts of the heater are hot. When moving, hold the heater only by the handle
provided.
10. Do not use the heater in areas such as garages where petrol, paint or other flammable
substances are used or stored.
11. Do not use near or point the heater to furniture, animals, curtains or other inflammable objects.
Keep combustible materials such as furniture, bedding and any other combustible materials at least 1
metre from the front and sides, and from the rear of the heater.
12. Do not place the cord under carpet or cover with throw rugs or furniture. Arrange the cord so that
it cannot be tripped over.
13. Do not place the heater on bedding or on thick and long pile carpet where the openings may be
blocked.
14. To reduce the risk of electric shock, do not immerse or expose the product or flexible cord to rain,
moisture or any liquid other than those necessary for correct operation of the product.
15. This product should not be used in the immediate vicinity of water, such as bathtub, washbowls,
bathroom swimming pool etc. where the likelihood of immersion or splashing could occur.
16. Switch off and unplug from outlet when not in use, before assembling or disassembling parts and
before cleaning. Remove by grasping the plug - do not pull on the cord.
17. A common cause of overheating is deposits of dust and fluff entering the heater. Ensure these
deposits are removed regularly by unplugging the heater, allowing it to cool and cleaning as
described in the Cleaning and Maintenance section.
18. Be sure that no other high current appliances are plugged into the same circuit with your heater
as an overload can occur.
19. Avoid the use of an extension cord as the extension cord may overheat and cause a risk of fire.
20. Do not use the appliance for other than its intended use.
10