Cleaning And Care - WMF Ambient Gebrauchsanweisung

WMF Ambient Herbs @home Single is not yet being used (Case B)
▪ Please follow the first four points in the section "Inserting a herb/plant
pot", from the instruction manual that was supplied with the WMF Ambient
Herbs @home Single.
▪ Insert the Plant Light's plug into the only free connector available inside
the casing that is intended for this purpose. In order to avoid damaging
it, the thin cable can be laid through the cable bushing, which is directly
aligned with the connection.
▪ Position the lower fixing hook in the corresponding recess below the
Cromargan® logo.
▪ The light housing can now be fixed to the stainless steel casing, by carefully
hooking the upper fixing hook over the upper end of the stainless steel
casing (see picture above).
▪ For further assembly instructions, please refer to the instruction manual
that was supplied with the WMF Ambient Herbs @home Single under the
section "Inserting a herb/plant pot", from Point 5.
Operation
Light setting with WMF Easy Touch Technology
▪ Touch the stainless steel casing of the WMF Ambient Herbs @home Single
at any point to switch the Plant Light on.
▪ If you touch the stainless steel casing a second time, both the Plant Light
and the Ambient Light on the WMF Ambient Herbs @home Single will light
up, each of them at 50% brightness.
▪ If you touch the stainless steel casing a third time, just the Ambient Light
will light up with 100% brightness.
▪ The fourth touch switches all lights off.
Light setting Plant Light
1st touch
(100% brightness)
2nd touch
(50% brightness)
3rd touch
4th touch
10
Ambient Light
X
(50% brightness)
X
(100% brightness)
X X
Tips:
▪ We recommend using the WMF Ambient Plant Light in addition to natural
daylight, as the Plant Light doesn't completely replace natural daylight.
▪ The recommended level of Plant Light illumination varies depending on
how much light the plant(s) need and on the amount of natural daylight
they get.
▪ It should be noted that many plants need a rest phase each day. Therefore,
continuous illumination is not advisable.

Cleaning and care

Unplug the WMF Ambient Herbs @home Single from the mains supply before
cleaning the Plant Light.
You can remove the Plant Light from the stainless steel casing to give it a
thorough cleaning.
To do this, first remove the stainless steel cachepot from the water tank and
unplug the Plant Light. Remove the light housing by carefully unhooking the
upper fixing hook by gently pressing on the stainless steel casing.
The Plant Light should never be immersed in water, only wiped down with a
damp cloth.
11