Basic Use - alza Tools AT-CD20V Bedienungsanleitung

BASIC USE

FIXING AND REMOVING THE DRILL
Note: The product is equipped with an electric brake.
The drill is equipped with a chuck, which allows the
drill to be fixed without using tools. No handles are
needed to fasten and loosen the drill or screwdriver
bits.
• Insert the drill bit into the chuck hole as deep as
possible.
• Firmly tighten the chuck by hand.
Note: Simply insert the short screwdriver bits be-
tween the jaws.
ROTATION DIRECTION SELECTION
REVERSE, FORWARD
The direction of rotation switch (7) allows you to change the
direction of the rotation of the spindle.
Change direction of rotation:
• Stop the engine and press button (7) left or right.
• When the switch is pressed to the left, the drill rotates to
the right (forward).
• When the switch is pressed to the right, the drill rotates to
the left (backwards).
• Always make sure the switch is in the correct position
before use. The direction cannot be changed while the
machine is running; always wait for the drill to come to
a complete stop.
• When not in use, you can set the direction switch to the neutral position (centre) when the motor
switch is locked.
Note: If the switch is not in the neutral position, the switch may be accidentally pressed, and the drill
switched on accidentally. Doing so may damage the machine or cause injury.
SPEED CONTROL SWITCH
When the switch (2) is pressed, the drill spindle rotates (assuming the direction selector (7) is in one
of the extreme positions). This switch is also used to continuously control the rotation speed elec-
tronically.
• The speed of rotation depends on the degree to which the switch button is pressed.
• The deeper it is pressed, the faster the drill rotates.
• When pressed lightly, the spindle rotates more slowly.
TORQUE CHOICE
By turning the ring (9) around the chuck, it is possible to set the maximum torque that the machine
ENGLISH 11